Magnetic drills are one of the essential sheet metal tools that provide safe, accurate, and efficient methods for drilling metal parts. These types of drills are especially efficient for drilling in inaccessible areas or drilling in a vertical or high position; Because with a powerful magnet that keeps the drill firmly in place, you won’t need any kind of clamp. However, for those who have just started using a magnet drill, it is very important to understand how to use this device correctly to get the best results and avoid possible accidents. A dull drill bit can make drilling difficult and also threaten your safety, so it is very important to use a sharp drill bit. In this article from Industrial Solutions – Nitto Kohki distributors, we will have an overview of the necessary steps for the correct use of magnetic drills.
Page Content
Proper Electrical Outlet and Ensuring That it is Healthy
Before starting work, check the electrical outlet to make sure it is healthy in terms of safety. If you see a bare wire in the electrical outlet, fix it first and then start drilling.
Not Wearing Loose Clothes
Another safety tip for working with a drill is to wear appropriate clothes, preferably work clothes. Wearing loose clothes or hanging jewelry may get stuck in the moving parts of the tool and cause accidents. So it will be necessary to pay attention to this point.
No Hand Contact with the Drill
The third point in observing the safety tips for working with a drill is not to keep the drill bit after finishing the work. Considering that the drill will get very hot while working with the drill, it is necessary to avoid contact with the drill for a few minutes and let it stop moving by itself.
Use the Right Drill
The drill bit is one of the most important parts of the drill and its correct selection has a significant impact on the quality of the work. Therefore, you should use a suitable drill to drill holes in different surfaces and environments in order to get a good result and not have problems and break the drill while working with the drill.
Do Not Put too Much Pressure on the Drill
Applying too much pressure to advance the job will not only fail, but also cause damage to the motor, breaking or jamming the bit in the workpiece, and causing the drill to slip. Because the drilling work is done by the motor itself there is no need to apply pressure to the drill.for more information visit industrialsolution.ae.
